Today I am sharing the sweetest card! Die cutting can be a pain, getting everything lined up correctly, but it can also provide a big POP! In today’s card, there is zero stamping involved, just a couple of passes through my die cutting machine!

Utilizing Lil’ Inker Design’s Bunnies & Bows set I simply ran each bunny through my machine on an A2 sized piece of white cardstock (Neenah Solar White 110lb). I used my T-square to ensure that they were as level, at their feet, as possible. I then chose two pieces of colored cardstock that I felt most closely matched the sequins I intended on using.

I attached that A2 panel to the card base, after attaching a sheet of acetate behind the bunnies, using mounting tape. The mounting tape was stuck a bit close to the bunnies, and in between them. The sequins can move, but it is tight. I wish I had left a little bit more space in between the bunnies, but I didn’t want my sequins to travel far outside those rabbits. Finally, the bows were added using a bit of Ranger Multi Matte Medium.

Thank you for viewing this sweet Easter/Spring card!

Follow me on Instagram!
Follow me on Facebook!
Follow me on Youtube!

Facebook
Facebook
YouTube
Pinterest
Pinterest
Instagram

Leave a Reply

Your email address will not be published. Required fields are marked *

Social media & sharing icons powered by UltimatelySocial